Mopar 4627063AC A/CLEANER

You can Select Your Vehicle to check if 4627063AC fits your vehicle.

To remove the air intake assembly on a 2.5L engine, start by detaching the cable from the negative terminal of the battery. Then, remove the air filter from the box and inspect it for dirt and moisture. Lift up on the clips or remove the band clamp that holds the air intake assembly to the throttle body. Remove the clamp retaining the air intake assembly to the box and lift the air intake tube from the engine compartment. Next, remove the nut from the bottom of the air filter box and partially lift the box up. Detach the warm air hose from the bottom of the box and label and remove any vacuum hoses. Finally, remove the air filter box assembly. For a 4.0L engine, start by detaching the cable from the negative battery terminal. Loosen the hose clamp and remove the attaching screws from the flexible air duct between the air filter box and the throttle body. Label and detach all vacuum hoses and detach the heat riser tube from the air filter box. Remove the upper half of the air filter box lid and the air filter element. Remove the bolts and nut from the floor of the air filter box and remove the box. For a 4.2L engine, detach the cable from the negative terminal of the battery and detach the flexible ambient air duct from the air filter box snorkel. Remove the wing nut, cover, and filter element. Label and detach all hoses from the air filter box and remove the box assembly. For V6 engines, detach the cable from the negative terminal of the battery and remove the engine cover. Disconnect the IAT sensor connector and loosen the crankcase ventilation hose from the top of the air filter box. Loosen the clamp securing the air intake hose to the throttle body and disconnect the hose. On 3.6L engines, detach the coolant hose from the retainers on the shroud. On all models, remove the mounting bolt(s) on the radiator shroud and lift the air filter box from the alignment pin. Firmly pull the air filter box, lid, and intake hose as an assembly upwards to disengage the pin(s) from the inner fender and remove from the vehicle.