Mopar 4896803AC ALTERNATR-Engine

You can Select Your Vehicle to check if 4896803AC fits your vehicle.

When replacing the alternator, it is important to bring the old one with you when purchasing a replacement unit. Ensure that the new/rebuilt unit looks identical to the old alternator, including the terminals, which should be the same in number, size, and location. Also, check the identification numbers on both alternators to make sure they match. Many new and remanufactured alternators do not come with a pulley installed, so you may need to switch the pulley from the old unit to the new/rebuilt one. Check with the shop regarding their policy on pulleys, as some may provide this service free of charge. For the 2.7L V6 engine, start by disconnecting the battery cable from the negative terminal. Then, remove the drivebelt and disconnect the battery cable from the B+ output terminal and the field wire electrical connector from the field terminal. Remove the upper and lower mounting bolts to take out the alternator. Installation is the reverse of removal, and don't forget to check the charging voltage to ensure the alternator is functioning correctly. For the 3.5L V6 engine, begin by disconnecting the battery cable from the negative terminal. Remove the drivebelt and the upper mounting bolt, as well as the support bracket bolt to remove the support bracket. Raise the front of the vehicle and remove the middle engine splash shield. Disconnect the battery cable from the B+ output terminal and the field wire electrical connector from the field terminal. Remove the lower alternator mounting bolts and take out the alternator. Reverse the steps for installation and check the charging voltage. For the V8 engine, start by disconnecting the battery cable from the negative terminal. Remove the drivebelt and raise the front of the vehicle on jackstands. Unsnap the plastic insulator cap from the B+ output terminal and remove the battery cable retaining nut from the B- output terminal. Disconnect the battery cable from the B+ output terminal and the field wire electrical connector from the field terminal. Working underneath the engine, remove the alternator support bracket nut and bolt, and then remove the support bracket. Remove the upper and lower mounting bolts to take out the alternator. Reverse the steps for installation and check the charging voltage.