Mopar 4695985AB Knuckle Front

You can Select Your Vehicle to check if 4695985AB fits your vehicle.

Loosen the rear wheel lug nuts, raise the vehicle and support it on jackstands. Block the front wheels and remove the rear wheel. Remove the rear hub/bearing assembly. Remove the wheel speed sensor from the brake backing plate. Remove the parking brake cable from the parking brake actuator lever. Then remove the cable from the brake backing plate. Remove the brake backing plate bolts. Using a length of wire, hang the brake assembly from the coil spring above the knuckle so that you do not need to remove the brake hose from the wheel cylinder. Remove the nuts and bolts attaching the forward and rear lateral links. Separate the upper control arm balljoint from the rear knuckle. Remove the nut and washer attaching the trailing link to the rear knuckle. Remove the shock absorber-to-knuckle nut and bolt. Remove the knuckle assembly from the vehicle. Installation: Installation is the reverse of removal. Make sure the shock absorber clevis bracket bolt is installed with the head of the bolt facing the rear of the vehicle. Reinstall the trailing link bushings in the same locations as when you removed them, and with the retainers installed with the cupped side of retainer facing away from the bushing and knuckle. Be sure to tighten all suspension fasteners to the torque. Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts to the torque. Drive the vehicle to an alignment shop to have the rear wheel alignment checked and, if necessary, adjusted.

Removal and installation of the steering knuckle.