Genuine Jeep Wagoneer Wheel Cylinder

Brake Wheel Cylinder

Enter your vehicle info to find more parts and verify fitment

  • Select Vehicle by VIN
  • Select Vehicle by Model
Select by VIN
Enter your VIN for the most accurate results.
Enter your VIN for the most accurate results.
or
Select by Model
-- Select Make --
-- Select Model --
-- Select Year --

2 Wheel Cylinders found

  • Jeep Wagoneer Wheel Cylinder - V2103056AA
    Diagram for Jeep Wagoneer Wheel Cylinder - V2103056AA
    View related parts

    Jeep Wagoneer WHEELCYLINDER-Wheel

    Part Number: V2103056AA
    • Other Name: Cylinder, Wheel Brake, Complete
    $19.00 MSRP: $20.90
    You Save: $1.90 (10%)
    Add to Cart
    More Info
    Fits the following Vehicles:
    • 1990 Jeep Wagoneer | 4 Cyl 2.1L Diesel, 4 Cyl 2.5L, 6 Cyl 4.0L
    Less Info
  • Jeep Wagoneer Wheel Cylinder - 4313056
    Diagram for Jeep Wagoneer Wheel Cylinder - 4313056
    View related parts

    Jeep Wagoneer Wheel Cylinder-Wheel

    Part Number: 4313056
    • Other Name: Cylinder, Wheel Brake, Complete; Wheel Cylinder
    More Info
    Fits the following Vehicles:
    • 1990 Jeep Wagoneer | 4 Cyl 2.1L Diesel, 4 Cyl 2.5L, 6 Cyl 4.0L
    Less Info

Jeep Wagoneer Wheel Cylinder Parts Questions & Answers

  • Q: How to rebuild a wheel cylinder?
    A: New wheel cylinders are available, which makes this job quite easy. If it's decided to rebuild the wheel cylinder, make sure that a rebuild kit is available before proceeding. Never overhaul only one wheel cylinder always rebuild both of them at the same time. Raise the rear of the vehicle and support it securely on jackstands. Block the front wheels to keep the vehicle from rolling. Remove the brake shoe assembly. Remove all dirt and foreign material from around the wheel cylinder. Completely loosen the Brake Line fitting, then remove the two wheel cylinder mounting bolts. Don't pull the brake line away from the wheel cylinder. Remove the wheel cylinder mounting bolts. Detach the wheel cylinder from the brake backing plate and place it on a clean work bench. Immediately plug the brake line to prevent fluid loss and contamination. If the brake shoe linings are contaminated with brake fluid, install new brake shoes. Remove the bleeder screw, piston cups, pistons, boots and expander assembly from the wheel cylinder body. Clean the wheel cylinder with brake fluid or brake system cleaner. Use compressed air to remove excess fluid from the wheel cylinder and to blow out the passages. Check the cylinder bore for corrosion and score marks. Crocus cloth can be used to remove light corrosion and stains, but the cylinder must be replaced with a new one if the defects cannot be removed easily, or if the bore is scored. Lubricate the new cups with brake fluid. Assemble the wheel cylinder components. Make sure the recessed sides of the cups face in. Place the wheel cylinder in position and install the bolts. Connect the brake line and tighten the fitting. Install the brake shoe assembly. Bleed the brakes. Check brake operation before driving the vehicle in traffic.

Related Jeep Wagoneer Parts