My Garage
My Account
Cart
Genuine Dodge Nitro Wiper Motor
Windshield Wiper Motor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Wiper Motors found
Dodge Nitro Wiper Motor
Dodge Nitro vehicles feature the Wiper Motor which has the sole purpose of operating the windshield wipers so that they remove rain, sleet and any other obstacle obstructing visibility. This electric motor is capable of running at different speeds hence enabling the drivers to control the speed of wiper based on the prevailing weather. According to the nature and needs of a car, Dodge Nitro Wiper Motors can be bought as new or as refurbished. In other cases, New Wiper Motors are obtained from the manufacturer directly, while the Rebuilt ones are used ones but are recycled back to the factory standards by replacement of some of their parts. It is an array that makes it possible for car owners to select the right service for their Dodge Nitro as they enjoy effective wiper operation.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Nitro Wiper Motor at great affordable prices. Moreover, all genuine Dodge Nitro Wiper Motor come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Nitro Wiper Motor Parts Questions & Experts Answers
- Q: How to replace the front and rear wiper motor assemblies on Dodge Nitro?A:Allow the removal of the front wiper motor assembly in the following way, Loosen the cable from the motor assembly's negative terminal on the battery. Put tape around the wiper blade to indicate the position of the wiper on the windshield and then cover and nuts are to be taken off. Lift of the wiper arm, get a hold of the lower part of the wiper and swing the wiper arm end in an up and down motion to remove it from the pivot then remove the wiper arms. If the wiper arm is frozen in the 'parked' position, then use the battery cable terminal puller to avoid damaging the arm. Thirdly, take off the cowl cover and then demate the wiring of the motor unit. Remove the two forward mounting bolts and two located in the center of the wiper assembly, after that pull the wiper assembly off of the mounting studs and take it out. Cessation also involves the opposite of installation where the items are removed, as it may be explained hereunder: At least for the rear wiper motor, the cable has to be removed from the negative terminal of the battery besides that the base cover of the wiper arm must be flipped up while removing the nut and wiper arm from the motor. The cover can now be removed from the shaft nut by peeling it off gently, and paint surface should be covered with some tapes. Pop off the wiper nut, followed by the bezel below it, and the gasket; after doing so, remove the tailgate/liftgate inner trim panel, and disconnect the wiring connectors. Unscrew the two screws on the mounting bracket but do not remove them mostly rather just loosen them to enable the motor to be slid out. To reinstall a new motor one needs to simply loosely install the assembly into the mounting holes, place the pivot shaft over the tailgate/liftgate hole, followed by the installation of a new gasket and bezel. Last but not the least, fix the pivot shaft mounting nut, tighten the motor mounting screws and the final assembling is done in sequence opposite to the sequence explained above.
