My Garage
My Account
Cart
Genuine Jeep Cherokee Power Steering Pump
Power Steering Pump Unit- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
10 Power Steering Pumps found
Jeep Cherokee Power Steering Pump
The Power Steering Pump of Jeep Cherokee automobiles plays a central role of transforming energy from the engine into hydraulic energy that makes the steering easier. This pump creates fluid pressure, which helps the driver to control and move the vehicle with ease especially when at slow pace of when trapped. The pump is usually connected to the crankshaft with the aid of a V belt or serpentine belt and usually has a separate or integral fluid tank. Different kinds of power steering systems are hydraulic and electronic and through the production years of Jeep Cherokee, various models employed these systems. Hydraulic systems retain a physical link by means of system so the vehicle could be steered manually if the power help give out. On the other hand, digital systems control the help supplied in relation to speed, and thus optimize results depending on the road context. Some Jeep Cherokee Power Steering Pump problems include leakage, noise and variance in the level of power boost, situations that may require steering check or pump replacement for more efficiency.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Cherokee Power Steering Pump at great affordable prices. Moreover, all genuine Jeep Cherokee Power Steering Pump come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Cherokee Power Steering Pump Parts Questions & Experts Answers
- Q: How to remove and install a power steering pump on Jeep Cherokee?A:Loosen the pump drivebelt and slip the belt over the pulley. Using a suction gun, suck out as much power steering fluid from the reservoir as possible. Position a drain pan under the pump and disconnect the high pressure line and fluid return hose. It may be necessary to remove the air cleaner housing for access to the return hose. Cap the ends of the lines to prevent excessive fluid leakage and the entry of contaminants. Remove the front attaching bolts and the rear attaching bolts and nuts, then lift the pump from the engine. If it is necessary to remove the pulley from the pump, first measure how far the pump shaft protrudes from the face of the pulley hub. Remove the pulley from the shaft with a special power steering pump pulley removal tool. This tool can be purchased at most auto parts stores. A special pulley installation tool is available for pressing the pulley back onto the pump shaft, but an alternate tool can be fabricated from a long bolt, nut, washer and a socket of the same diameter as the pulley hub. Push the pulley onto the shaft until the shaft protrudes from the hub the previously recorded amount. Installation of the power steering pump is the reverse of the removal procedure. Be sure to bleed the power steering system following the procedure.
