My Garage
My Account
Cart
Genuine Jeep Comanche Heater Core
HVAC Heater Core- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Heater Core found
Jeep Comanche Heater Core
Heater Core in Jeep Comanche is used in climate control system and part of the heaters which bring warm air to the car cabin. This in turn works like a radiator and it cools the water and antifreeze mixture which is then circulated within the car to release heat from the engine. Made from aluminum or brass, it comes with fins to increase heat transfer rate and is supplied with a fan to force air through the core to warm the cabin. In various years of Jeep Comanche models, it can use different styles of Heater Core, such as the heated air control and temperature control such as a valve and with the highly developed system utilizing electromechanical actuators to control the flow of heat. One of the often seen problems with HCM is obstruction, leakage, and corrosion that makes repairs even more challenging because of the HCM dashboard. In general, Heater Core is important for comfort Climate Jeeps in specially Comanche cars and as a secondary radiator to help in cooling engines.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Comanche Heater Core at great affordable prices. Moreover, all genuine Jeep Comanche Heater Core come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Comanche Heater Core Parts Questions & Experts Answers
- Q: How to remove the heater core on Jeep Comanche?A:To remove the heater core, first discharge the AC system and disconnect the battery's negative cable. Drain the cooling system and disconnect the heater hoses, blower motor connector, and A/C hoses. Label and disconnect the electrical wires at the AC relay, Thermostat, and blower motor resistors. Cut the retaining strap holding the blower/evaporator housing to the heater core housing. Remove the housing nuts from the firewall and the evaporator drain tube. Remove the right kick panel and instrument panel support bolt. Pull out the right side of the dash and rotate the housing to disengage it from the dash panel. Remove the blower/evaporator housing and the heater core. To install, position the heater core in the housing and install the screws. Reinstall the remaining parts in reverse order, refill the cooling system, and have the AC system evacuated, recharged, and leak tested. Check for proper operation. For 1997 and later models, additional steps may be required.
