My Garage
My Account
Cart
Genuine Jeep Patriot Hood Cable
Hood Release Cable- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Hood Cables found
Jeep Patriot Hood Cable
Jeep Patriot Hood Cable is the essential link allowing drivers to pop the hood for maintenance while locking the latch in place during travel. The Hood Cable runs from the cabin release handle to a junction located on the front panel. The cable then splits into two, heading towards each latch. This way, a single pull lifts both catches at the same time. Moisture, cracking, and stretching over time can weaken the Hood Cable, which can cause the lever to feel loose or the hood to be stuck shut. Replacing the unit in this case reclaims a factory appearance and keeps the Jeep engine bay accessible for fluid checks or repairs. The early Patriot models and later refreshes gained a steel strand design instead of switching to electronic releases, meaning no style changes for owners, only the original mechanical Hood Cable, which uses simple pull force. The only difference in design is routing length, which was changed slightly when Jeep updated grille shapes, but both versions work the same and swap with no special tools. Lubricating and maintaining the Hood Cable will allow every Jeep Patriot to open confidently on the first pull. This protects components from the weather and saves time in the driveway. By paying attention to this little part regularly, any Patriot is road-ready.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Patriot Hood Cable at great affordable prices. Moreover, all genuine Jeep Patriot Hood Cable come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Patriot Hood Cable Parts Questions & Experts Answers
- Q: How to remove and install a front hood cable and hood latch on Jeep Patriot?A:To remove the latch first, you are required to unbolt the bracket attaching the latch to the radiator support then, disconnect the latch assembly. Then, loosen the hood release cable and put a marker on the position of the hood latch before removing the bolts. When installing, do it the other way round of how it was removed. As for handling the cable, the steps include: the first is to release the end of the cable and then move the cable case in the keyhole slot of the hood latch with the help of pinching the barb present in the cable case ends; if you are troubling to release the end of the cable then the sequence must be reversed. Disconnect the cable from the latch, then, in the passenger compartment, remove the bolts and release the hood release handle and thus sever the connection between the cable end. under the dash you may have to take off the rubber cable which insulates it from the hole in the dash panel. Thread a long string or wire thru the engine compartment end of the cable, remove the cable from various clips and pull it through the fire wall into the passenger area. Attach the string or wire to the new cable and pass it through the firewall into the engine compartment and similarly, re-establish the connection by performing the reverse of the aforesaid procedure.
