My Garage
My Account
Cart
Genuine Ram 2500 Release Bearing
Clutch Release Throw Out Bearing- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Release Bearing found
Ram 2500 Release Bearing
The Ram 2500 Release Bearing presses against the spring of the clutch every time the driver steps onto the pedal, briefly cutting engine torque on the gearbox so that shifting feels effortless. This part is mounted to the clutch housing and it travels along a hollow shaft. The fork is either operated by a hydraulic push or an older cable operated system. Both these systems have been applied at different times on Ram 2500 trucks. However, they perform the same job. Essentially, what occurs here is that as the fork slides forward, it unloads the pressure plate and allows the disc to spin freely. Throughout the decades, Ram 2500 editions have alternated between these setups yet the fundamentals stay unchanged. The Release Bearing must always glide silently. When the pedal is released, a spring moves the Release Bearing to the home position. Power flow is resumed and the truck pulls hard again. Since every movement of the engine and chassis depends on this precise dance, any worn Release Bearing warns of trouble with grinding noises, vibration in the pedal, stiff travel, or balky shifting. A factory spec replacement keeps towing confidence high for any Ram 2500 if the Release Bearing seizes.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Ram 2500 Release Bearing at great affordable prices. Moreover, all genuine Ram 2500 Release Bearing come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Ram 2500 Release Bearing Parts Questions & Experts Answers
- Q: How to remove Pressure Plate,Release Bearing and Clutch Fork on Ram 2500?A:To remove the clutch components, begin by raising and securely supporting the vehicle on jack stands. Disconnect the clutch release cylinder from the clutch housing without disconnecting the hydraulic fluid line. Proceed to remove the transmission, leaving the clutch fork and release bearing attached to the clutch housing. To support the clutch disc during removal, insert a clutch alignment tool through the clutch disc hub. Inspect the flywheel and pressure plate for indexing marks; if absent, create your own to ensure proper alignment during installation. Gradually loosen the pressure plate-to-flywheel bolts in a criss-cross pattern and remove them along with the pressure plate and clutch disc. Inspect all components, including the flywheel for defects, clutch disc for wear or damage, release bearing for replacement, and pressure plate for wear or damage. Clean the surfaces thoroughly and reinstall the flywheel. Align the clutch disc and pressure plate with an alignment tool and finger-tighten the pressure plate-to-flywheel bolts. Center the clutch disc using the alignment tool, then gradually tighten the bolts in a criss-cross pattern to the specified torque. Remove the alignment tool, lubricate the release bearing and related parts with high-temperature grease, reinstall the clutch release bearing if removed, and proceed to reinstall the transmission and all previously removed components. Finally, lower the vehicle.
