Separate the lids from the sides of the console by using a plastic trim device or a screwdriver wrapped in tape. Conversely lift off and remove shifter trim ring as well as cover. Specifically, take out the shifter bezel. Then separate shift cable from shift lever as well as console. Thereafter, get rid of the console mounting screws and lift it up. After that, make sure you disconnect all wiring harnesses before taking away console. The reverse of removal is installation here. On 65RFE 6-speed models, however, to dislodge the trim ring situated at either side of the console bezel one uses a plastic trim device or a screwdriver wrapped with tape. Nevertheless, remove bezel first. It is also necessary to eliminate rubber insert from console bezel itself; this occurs next Remove front two mounting screws on bezel only when it is done using a plastic trim tool or screw driver covered with tape carefully so that you may pull up and lean down then detach off the whole thing altogether Remove the rubber lining for central storage tray thereby unfastenings fasteners and discarding tray Installation involves performing operations in an order opposite to those during removal.