Mopar 4805761AD Headlamp

You can Select Your Vehicle to check if 4805761AD fits your vehicle.

Open the hood and locate the headlight vertical adjustment screw for each headlight in the upper radiator crossmember. Each headlight has a vertical adjustment screw; there are no horizontal adjustment screws. There are several ways to adjust the headlights. The simplest method requires an open area with a blank wall and a level floor. Position masking tape vertically on the wall in reference to the vehicle centerline and the centerlines of both headlights. Position a horizontal tape line in reference to the centerline of the headlights. It might be easier to position the tape on the wall with the vehicle parked only a few inches away. Adjustment should be made with the vehicle parked 25 feet from the wall, sitting level, the gas tank full and no unusually heavy load in the vehicle. The high intensity zone should be vertically centered with the exact center about three inches below the horizontal line. Have the headlights adjusted by a qualified technician at the earliest opportunity. This procedure applies only to vehicles equipped with fog lights. Park the vehicle 25 feet from the wall. Tape a horizontal line on the wall that represents the height of the fog lights and tape another line four inches below that line. Using the adjusting screw on each fog light, adjust the pattern on the wall so that the top of the fog light beam meets the lower line on the wall. Repeat this procedure for the other fog light.

Four - two upper and two lower.