Mopar V2508352AA Axle Hub Assembly-Disc Brake Hub Front

The hub and bearing assembly cannot be disassembled and must be replaced if either component is damaged or worn. To remove the assembly, start by removing the wheel center cap/hubcap on 4WD models. Loosen the drive axle/hub nut and the front wheel lug nuts. Raise the front of the vehicle and secure it on jack stands. Remove the wheel, disc brake caliper, caliper mounting bracket, brake disc, ABS wheel speed sensor, and sensor wire bracket. On 4WD models, remove the axle hub nut. Unbolt the hub assembly from the steering knuckle and tap it out of the knuckle bore. If the drive axle sticks in the hub splines, use a puller to push it out. To install the new hub assembly, clean the opening in the steering knuckle and attach the assembly, tightening the hub-to-knuckle bolts securely. On 4WD models, install and tighten the hub nut. Complete the installation by following the reverse steps of removal. Lower the vehicle and tighten the hub nut and lug nuts to the specified torque.