Mopar 55157225AB Headlight Assembly Driver Side

One of the headlight has a single adjusting screw for the vertical movement which is best seen from above. The best location for warranting adjustment of headlights is an open plain with a bare wall and a flat bearing surface. Tape the wall with a vertical and a horizontal strip with the vertical one running along the centre-line of the vehicle being investigated and the width of the headlight; it is convenient to position the tape when the car is parked slightly away from the wall with the headlight centre line touching the wall. Make certain that the vehicle is 25 feet away from the wall, and its suspension is level, fuel tank is full, and it has no heavy loads during the suspension adjustment. The high intensity zone should be superimposed directly on the top of the datum line and the exact center, is about two and a half centimeters below the straight line The headlights must be adjusted as soon as possible by a dealer service department. Fog lights are optional, and to set them, park the car 25 feet away from the wall or other vertical structure, then draw a horizontal line to match the position of the fog lights and a second line four inches below the former line. Adjust the beam for each fog light to where the top of the beam is horizontal with the lower line on the wall using the adjusting screw. The roof-mounted light bar is also optional; park the vehicle 25 feet from the wall and align a horizontal strip of tape at 7 feet 9 inches from the bottom of the ve Turn off three of the lamps and use the adjustment screw in the back to aim the fourth one: the center of the tape line should be located at the center of the high intensity zone. Do the same with the other lamps.