Mopar V1013701AA Front Disc Brake Pad Kit

To replace the rear brake pads, follow these steps, wash the rear caliper with brake system cleaner. Use a C-clamp to compress the piston into its bore, being mindful of the master cylinder reservoir. Remove the caliper mounting bolts. Swing the caliper upwards (removing anti-rattle springs on later models), and wire it to the rear coil spring to prevent stress on the brake hose. Pry the outer pad from the rear caliper with a screwdriver, remove the anti-rattle clips and bushings, and apply anti-seize to the cleaned bushings. After cleaning, install the anti-rattle clips, align the protrusions on the outer brake pad with the caliper frame slots, and push the pad into the caliper until it seats properly. Engage the upper part of the brake pads with the upper anti-rattle clip. Swing the caliper rear down, and install and tighten the rear caliper bolts to torque specifications.

To prepare for brake pad replacement on both front and rear disc brakes, begin by removing the cap from the brake fluid reservoir and loosening the wheel lug nuts. Then, raise the front of the vehicle securely on jack stands and remove the front or rear wheels, working on one brake assembly at a time while using the assembled brake for reference if needed.

Install the wheels and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque. Finally, check the brake fluid level, adding as necessary, and check for fluid leakage while ensuring the brakes operate normally before driving in traffic.