Mopar 68079412AC Engine Water Pump Front

You can Select Your Vehicle to check if 68079412AC fits your vehicle.

Remove all accessory brackets from the water pump, tying the units aside with the hoses attached. Clean the engine and new water pump mating surfaces with lacquer thinner or acetone. Apply RTV sealant to the engine side of the new gasket and apply a thin layer of RTV sealant to the gasket mating surface of the new pump.

A failure in the water pump can cause serious engine damage due to overheating. There are three ways to check the operation of the water pump while it's installed on the engine. If the pump is defective, it should be replaced with a new or rebuilt unit. With the engine running at normal operating temperature, squeeze the upper radiator hose. If the water pump is working properly a pressure surge should be felt as the hose is released. Water pumps are equipped with weep or vent holes. If a failure occurs in the pump seal, coolant will leak from the hole. In most cases, you'll need a flashlight to find the hole on the water pump from underneath to check for leaks. If the water pump shaft bearings fail, there may be a howling sound at the front of the engine while it's running. Shaft wear can be felt if the water pump pulley is rocked up and down. Don't mistake drivebelt slippage, which causes a squealing sound, for water pump bearing failure.