Mopar 68197299AA Engine Cooling Radiator

You can Select Your Vehicle to check if 68197299AA fits your vehicle.

To remove the radiator, start by having an air conditioning technician discharge the system and recover the refrigerant. Then, disconnect the negative battery cable and raise the front of the vehicle on jackstands. Remove the engine cover, air filter and intake hose assembly, and drain the cooling system. Take off the front bumper cover and disconnect the electrical horn connectors. On newer models, remove the under-vehicle splash shield. For 2015 and later models, remove the large multi-purpose bracket to the front of the radiator/condenser by following a series of steps. Disconnect the upper and lower radiator hoses and the electrical connectors for the radiator fan. Remove the engine cooling fan assembly if necessary. Disconnect the A/C lines attached to the condenser and remove the transmission cooler bracket. On older models, compress the plastic tabs on top of the radiator to release it from the support frame. On newer models, remove the Torx screws and tilt the radiator rearward to release it. Lift the radiator and air conditioning condenser assembly from the vehicle and separate the condenser from the radiator. Check the radiator for leaks and damage, and have it repaired if necessary. Clean the radiator with a garden hose before reinstalling it. Check the rubber mounts and replace them if needed. To install the radiator, make sure the A/C condenser is properly attached and seat the radiator into the lower rubber mounts. Fill the cooling system with the proper mixture of antifreeze and water, start the engine to check for leaks, and have the air conditioning system recharged.