Mopar 33000153 Sensor-Manifold Absolute Pressure

The engine coolant temperature sensor, a thermistor that varies resistance with temperature, is essential for the vehicle's operation. Testing involves measuring its resistance when cold and warm; a significant difference could indicate sensor failure. Replacing it necessitates preparing the new sensor with Teflon sealing, unplugging the electrical connector, and swiftly replacing the sensor to minimize coolant leakage. The manifold absolute pressure (MAP) sensor monitors intake manifold pressure changes, aiding the ECM in fuel delivery and ignition timing control. Testing involves connecting jumper wires, and a voltmeter should read about 4.5 to 5 volts with the ignition on and fluctuate when the engine warms up; failure may trigger Code 3Replacement requires detaching the vacuum hose, unplugging the electrical connector, and removing mounting screws. The oxygen sensor, positioned in the exhaust system, monitors exhaust gas oxygen content to inform the ECM's fuel mixture control. Testing with a voltmeter at normal operating temperature should result in voltage fluctuations; a lack of variation might indicate sensor or fuel system issues, leading to Code 13 or 4 The throttle position sensor (TPS) on the carburetor float bowl helps the ECM determine fuel delivery based on throttle valve angle. Check its resistance with an ohmmeter, and if it's inconsistent instead of progressive as you move the throttle, replace it. Replacement involves unplugging the electrical connector and removing the TPS assembly. Adjustment, if needed, requires drilling a hole in the adjustment screw's plug, connecting terminals, and adjusting the screw to achieve a specific voltage reading. Finally, the plug is replaced or sealed with RTV.