Mopar 56007299 Switch As-W/S WIPER/WSHR-Intermittent

Unplug the electrical connector and tape it flat against the harness. Remove the turn signal switch without pulling the connector out of the column, just enough for access to the housing screws. Remove the ignition lock cylinder. Bend a straightened paper clip into a hook to lift the key warning buzzer switch out. Remove the four screws or bolts to lift the housing and shroud assembly off the column. Remove the wiper/washer switch actuating lever, the switch cover, and the pivot screw to detach the wiper/washer switch. Install the new switch and cover. Ensure the dimmer switch rod is connected. Position the housing and shroud assembly on the steering column with the lock pin forward of the slot in the lock rack. Install the screws to carefully mate the assembly. Finally, install the key and lock cylinder assembly, ensuring the lock pin extends fully when the key is in the lock position, and complete the installation in reverse order of removal.