Mopar 68211321AA Tube-EGR

You can Select Your Vehicle to check if 68211321AA fits your vehicle.

The EGR valve, if equipped, is located on the front of the right cylinder head. To remove the EGR valve on 2010 and earlier models, remove the air intake duct and air filter housing. Disconnect the electrical connector by sliding the red lock forward, depressing the release tab, and pulling off the connector. Remove the EGR tube mounting flange bolts and the EGR valve mounting bolts. Remove the valve and discard the old EGR tube and EGR valve gaskets. For 2016 and later models, disconnect the cable from the negative terminal of the battery and drain the cooling system. Remove the engine cover, disconnect the electrical connector and cooler hose from the EGR valve. Remove the mounting nuts and detach the EGR valve from the cylinder head. Clean the mating surfaces and install a new gasket. Position the EGR valve against the cylinder head and tighten the nuts. Connect the cooler hose and install the clamp. Reconnect the electrical connector and install the engine cover. Reconnect the cable to the negative terminal of the battery and refill the cooling system. For the EGR tube on 2010 and earlier models, remove the air intake duct and air filter housing. Remove the EGR tube mounting flange bolts and the wire retaining clip that secures the other end of the EGR pipe to the throttle body. Installation is the reverse of removal, ensuring the EGR tube mounting flange bolts are tightened properly.