To replace the power mirror control switch, carefully pry the switch assembly from the instrument panel using a small screwdriver, then disconnect the electrical connector and remove the switch by disengaging the tabs. Installation follows the reverse of the removal process. For the accessory bezel switches, which include the rear window defogger, wiper/washer, and traction control switches, first remove the center bezel, then detach the switch bezel from the dashboard by removing the retaining screws. Disconnect the electrical connectors and remove the switch bezel housing, and to remove a switch from the bezel housing, pull the retaining clips out and slide the switch out. Installation is again the reverse of removal. For the front power window control switches, carefully pry the switch assembly from the dashboard, disconnect the electrical connector, and remove the switch, with installation being the reverse of removal. For the rear power window control switches, carefully pry the switch assembly from the center console, disconnect the electrical connector, and remove the switch, with installation following the same reverse procedure.