My Garage
My Account
Cart
Genuine Dodge Nitro Exhaust Manifold
Engine Exhaust Manifold- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
12 Exhaust Manifolds found
Dodge Nitro Exhaust Manifold
The Exhaust Manifold used in Dodge Nitro cars is very vital in channelling hot emitting gases from the engine to the exhaust system hence optimizing the performance of the Dodge Nitro engine. Located on the top of the exhaust system, manifold gathers exhausts from several cylinders, it generally consists of a series of long twisted tubes, which can equal in number to the number of engine cylinders. Exhaust manifolds of the Dodge Nitro mostly call for cast iron or stainless steel while headers, which are after-market parts, can help in improving the performance by decreasing the restricting aspect of the exhaust system as well as enhancing the rate at which exhaust gas moves. These headers can increase engine efficiency by way of pressure differentials which help exhaust scavenging. When the exhaust manifold gets bad, then it affects the performance of the car, and dangerous fumes may leak thus necessitating replacement for the health of the users and functionality of the car.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Nitro Exhaust Manifold at great affordable prices. Moreover, all genuine Dodge Nitro Exhaust Manifold come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Nitro Exhaust Manifold Parts Questions & Experts Answers
- Q: How to remove and install the exhaust manifold in four cylinder engine on Dodge Nitro?A:To remove the exhaust manifold to begin with one has to lift the front portion of the car and place it on jack stands. The exhaust pipe has to be disconnected from the exhaust manifold before lowering the vehicle body down. Next, air filter housing and bracket, exhaust manifold heat shield will be detached in the next step. To accomplish this, remove the bolt and nut which secures the electrical connector for the oxygen sensor and then release the sensor from the exhaust manifold. Loosen the mounting bolts to remove the exhaust manifold with the old gasket also. For the inspection, cracks or damages to the exhaust manifold should be checked, and if these are present then it can be replaced. Before installing the exhaust manifold, tighten the bolts and clean the threads with a wire brush on any bolts which are bent or broken. Scrape all the gasket material from both contacting surfaces, running the scraper carefully not to nick the surfaces as this will explain to leakage. Check the respective mating surface with a straight edge and a feeler gauge and in the event of excessive warpage it would be necessary to replace or machine them. For installation put a new gasket on the exhaust manifold and tighten the mounting bolts with hands only. Lift the front of the vehicle once more and tighten the exhaust pipe bolts by the use of your hand to sine the nuts. Tighten the exhaust manifold mounting bolts starting from the middle and then from the outside and then tighten exhaust pipe mounting bolts. The following steps, therefore, proceed in the reverse order from that of removal.
