My Garage
My Account
Cart
Genuine Dodge Nitro Hood Latch
Engine Hood Latch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Hood Latches found
Dodge Nitro Hood Latch
Hood Latch in Dodge Nitro automobiles is therefore important since it cancels the chances of the hood opening during operations. This part is located below the lower front part of the hood to provide an adequate safety shield of major parts such as the engine, the radiator, and the battery when it's in motion. Specific to models of Dodge Nitro, a certain mechanism is set with the Hood Latch for the purpose of achieving an optimum seal in this particular component. Although the overview does not point out differences in types and styles of Hood Latch used in different Nitro vehicles, the primary concern is still the significance and function of Hood Latch in safety of the vehicle and protection of its components. In general it can be concluded that the Dodge Nitro Hood Latch is an essential component of the car's operation and safety.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Nitro Hood Latch at great affordable prices. Moreover, all genuine Dodge Nitro Hood Latch come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Nitro Hood Latch Parts Questions & Experts Answers
- Q: How to remove the Hood Cable and Hood Latch on the Dodge Nitro?A:For models from 2002 to unscrew the Grille, and then to turn out screws from the center vertical latch bracket. A circle should be made around the latch and two nuts must be unscrewed and the cable disconnected and the latch should be pulled off. On the 2003 and on models, the grille support has three fasteners, and on the 2007 and earlier models, the grille support will require removal to reveal the latch assembly. Once more, draw a circle at the latch, unscrew the two nuts, cut the cable, and retire the latch. To access the diagonal of the cable, begin with the removal of the battery and the latch, then the Powertrain Control Module. Then, remove the left side scuff plate and kick panel; then use a screwdriver to loosen the hood release handle and then disconnect the cable by pushing down the two black clips on the cable end. Disconnect the cable at the engine compartment, free the clip on the cable and pass the grommet through the firewall and then pull in the cable from the inside of the vehicle. Reinstallation is done in the reverse manner to guaranty that the cable grommet sits in correctly in the firewall.
