To eject the radio, the ignition system should be switched On and the Scan and Set buttons pushed simultaneously. Pull out cables from negative battery terminals. Start by removing centre instrument panel on a bezel by pulling back it using plastic trim tool and unscrewing the screws beneath upper storage tray. Slowly draw bezel backward until it comes off wiring. Take out four screws that hold down radio then pull it through dashboard; disconnect electrical connectors antena cable too. To remove speakers, remove cables from negative battery terminals Remove door trim panel for front door speakers and take out four screws which held speaker in place Unplug the connector to remove speaker Revove covers near windshield in instrument panel for center instrument panel speaker and end speakers then open them up to reveal screwes at bottom where they are attached to one of these things that are put together so they can produce sound like music or words coming out through their mouths instead having none outside (I am not sure this is what you mean here but I would expect something similar) Take off top cover connecters At rear cab side or rear door of vehicle , get rid of B-pillar lower trims or rear door trim panels and undo three screws attaching loudspeakers Pushing each up, unplug wiring from Woofer as well as undo mountings bolts thereof For headliner speaker on quad cab models, use a long narrow blade screw driver wrapped with cloth tape to pry off speaker cover above it Disconnecect two clips securing it then detach harness for wires before extracting.