Genuine Dodge Ram 1500 Shock Absorber

Dodge Ram 1500 Shock Absorber Parts Questions & Answers

• ABSORBER-Suspension
  52855791AC
  Q: What should be checked Shock Absorber and CV boot?

  A: The steering linkage and suspension components should be checked periodically. Worn or damaged suspension and steering linkage components can result in excessive and abnormal tire wear, poor ride quality and vehicle handling, and reduced fuel economy. To check the shock absorbers, park the vehicle on level ground, turn off the engine, and set the parking brake. Push down at one corner of the vehicle and release it, noting the movement of the body. It should stop moving and come to rest in a level position within one or two bounces. If the vehicle continues to move up-and-down or fails to return to its original position, a worn or weak shock absorber is likely the reason. Repeat this check at each of the three remaining corners of the vehicle. Raise the vehicle and support it securely on jack stands. Check the shock absorbers for evidence of fluid leakage. A light film of fluid is no cause for concern, but if leakage is noted, replace the shocks as a set. Also, check the shocks to ensure they are securely mounted and undamaged, and check the upper mounts for damage and wear. Moving on to the steering and suspension check, visually inspect the steering and suspension components for damage and distortion, including seals, boots, bushings, and leaks. Examine the bushings where the control arms meet the chassis. Clean the lower end of the steering knuckle and have an assistant grasp the lower edge of the tire and move the wheel in-and-out while checking for movement at the steering knuckle-to-control arm ball joint. If there is any movement, the suspension ball joint(s) must be replaced. Grasp each front tire at the front and rear edges, push in at the front, pull out at the rear, and feel for play in the steering system components. If any free play is noted, check the idler arm and the tie-rod ends for looseness. Finally, for 4WD models, check the CV Boot for tears, cracks, and loose clamps. If there is any evidence of cracks or leaking lubricant, they must be replaced.