My Garage
My Account
Cart
Genuine Dodge Ram 3500 Intake Manifold
Engine Intake Manifold- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
14 Intake Manifolds found
Dodge Ram 3500 Intake Manifold Plenum
Part Number: 68038759AA$509.24 MSRP: $585.00You Save: $75.76 (13%)
Dodge Ram 3500 Engine Intake Manifold Complete Assembly
Part Number: 5175896AB$579.12 MSRP: $847.00You Save: $267.88 (32%)
Dodge Ram 3500 Intake Manifold
The Intake Manifold of Dodge Ram 3500 vehicles help to supply the required air and fuel to the engine cylinder and hence the name intake manifold. This include a number of tubes that channel the air from the air filter through the throttle body as well as housing temperature, airflow and pressure sensors. Early systems for the Dodge Ram 3500 intake manifold were forged from aluminum or cast iron, however, the modern production employs composites from plastic. Some Dodge Ram 3500 vehicles can include the introduction of variable-length intake manifolds which increases power, torque and fuel economy because they change the length of the intake manifold. This technology get the premier airflow using the Venturi effect and resonance of Helmholtz under various loads of the engine. In general, the construction of the intake manifold used in the Dodge Ram 3500 and materials used are critical in maintaining the efficiency and power of the engine with a consideration of problems such as those that affect airflow, for instance, breakdowns in gaskets or hoses.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Ram 3500 Intake Manifold at great affordable prices. Moreover, all genuine Dodge Ram 3500 Intake Manifold come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Ram 3500 Intake Manifold Parts Questions & Experts Answers
- Q: What is the Intake Manifold replace Process for Dodge Ram 3500?A:For 2009 models, disconnect the negative battery terminals, wiring from the EGR temperature sensor and EGR valve actuator, oil dipstick tube fasteners, intercooler outlet tube, air transfer tube, and air inlet. Disconnect the fuel supply tubes and lines, wiring from the sensor at the rear of the fuel rail, and high pressure fuel line from the dump valve. For 2010 and later models, disconnect the left intercooler tube from the EGR air flow control valve, remove the EGR crossover tube, and disconnect interfering wiring harnesses. Remove the oil dipstick tube bolts and intake manifold bolts, and install a new gasket. To access the intake air heater grids, disconnect the heater cable, positive and ground cables, intake air heater manifold bolts, and dipstick tube mounting bracket bolt. Disconnect the fuel injector wiring harness and pressure sensor wiring harness, and remove the air intake heater mounting bolts. During reassembly, use new upper and lower heater block gaskets. To replace the intake air heater relay, disconnect the negative battery terminals, label and disconnect the trigger wires, remove the nuts from the cable terminals, and remove the relay mounting bracket bolts.
