My Garage
My Account
Cart
Genuine Jeep Comanche Throttle Body
Fuel Injection Throttle Body- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Throttle Body found
Jeep Comanche Throttle Body
The Throttle Body in Jeep Comanche is so vital since it controls the flow rate of fresh air into the engines which is of great importance in the fuel-injected vehicle. Located between the air cleaner and intake manifold it provides butterfly valve which changes depending on the accelerator pedal. When the pedal is pressed, the valve is opened thus allowing in more air and at the same time sensors relay to the PCM to open up fuel. Jeep Comanche models have been equipped with Throttle Body Injection (TBI) as well as with progressive multi-port fuel injection. TBI is a rudimentary systems that has injectors with the throttle body while new creations of fuel injection separate fuel management from the throttle body and such parts as IAC valve and TPS. The shift from mechanical throttle to ETC improves vehicle performance and safety because mechanical connection is removed and ETC can interact with electronic stability systems.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Comanche Throttle Body at great affordable prices. Moreover, all genuine Jeep Comanche Throttle Body come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Comanche Throttle Body Parts Questions & Experts Answers
- Q: How to remove and install a throttle body on Jeep Comanche?A:Detach the cable from the negative battery terminal. Detach the vacuum hoses from the throttle body upper bonnet, release the mounting clips and remove the upper bonnet. Remove the three mounting nuts and lift off the lower bonnet. Disconnect the ISA motor harness connector. Detach the fuel supply and return lines from the throttle body. Remove the accelerator cable and return spring. Detach the wire harness connector from the injector by compressing the lock tabs and lifting up. Identify and label the vacuum tubes at the back of the throttle body so you can install them in their original locations. Detach the vacuum tubes from the throttle body. Detach the TPS connector. Remove the throttle body mounting nuts and remove the throttle body. Remove any old gasket material or dirt from the mating surfaces of the intake. If you are replacing the throttle body assembly, remove the ISA motor and Throttle Position Sensor. Install them on the replacement throttle body and adjust them. Installation is the reverse of removal. Be sure to use a new gasket and lighten the mounting nuts to the specified torque.
