Chrysler 5003550AA Brake Hub And Bearing

To remove the cotter pin, nut lock, and spring washer, loosen the drive axle/hub nut and wheel lug nuts. Raise the vehicle and remove the wheel, brake caliper, and brake disc. Separate the tie-rod end and speed sensor cable routing bracket. Separate the steering knuckle from the lower control arm balljoint. Support the driveshaft and pull the steering knuckle away. Remove the cotter pin and nut from the upper balljoint stud. Mount the steering knuckle in a vise and remove the hub/bearing mounting bolts. Install the hub/bearing and remaining components in reverse order. Tighten all nuts/bolts to the torque. Install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts. Have an assistant apply the brakes and tighten the driveaxle/hub nut.

To replace the rear hub/bearing assembly, begin by loosening the wheel lug nuts and raising the vehicle securely on jackstands. Remove the wheel and the brake drum. Remove the rear hub/bearing dust cap with a hammer and chisel, and then remove the retaining nut. Discard it and pull the assembly off the rear spindle. To begin installing, use a new retaining nut. Install the wheel. Lower the vehicle and tighten the lug nuts.