Jeep 5106019AA Clutch Flywheel

To remove the transaxle, the following procedure is followed, The position of the driveplate to the crankshaft is marked so as to ease the positioning during the reassembly. Then unbolt the driveplate from the crankshaft; there is a tool which is available in counter of any auto parts store by the name of 'Dog' which holds the driveplate tightly while loosening the bolts of the driveplate or you can use the screw driver and can wedge it in the ring gear teeth of the driveplate. It is done after the removal of the driveplate and involves cleaning and scrutinizing the mating surfaces of the driveplate and crankshaft, with replacement of the crankshaft rear main seal if it is worn or leaking as you get ready to reinstall the driveplate. For installation, centre the driveplate over the crankshaft, be utilising the previously made match marks and then apply thread lock on the threads of the bolt before tightening it. Put the holding tool or insert the blade of the screwdriver in between of the ring gear teeth so that to immobilise the driveplate then tighten the bolts to the recommended torque only. The balance of the installation is done in the reverse order to the removal.