Jeep 5035102AA Starter Motor

To remove the starter in 2.7L Charger and all 300 V6 models: Remove the bolt securing the intermediate steering shaft to the lower steering coupling shaft and separate the two shafts. On all 2011 and later V6 models, remove the intermediate shaft completely. Remove the left-side catalytic converter. On 3.6L models, remove the starter motor heat shield. On all models, remove the nut securing the battery cable to the terminal stud on the starter solenoid, disconnect the cable from the terminal stud, and disconnect the electrical connector from the spade terminal on the solenoid. Remove the starter mounting bolts and the electrical harness/oil cooler line clip. To remove the starter, pull it forward and down, work it up over the exhaust pipe, then work it past the disconnected steering shafts. Installation is the reverse of removal.

Disconnect the cable from the negative terminal of the battery by loosening the nut and lifting the cable away.

If the starter does not activate when the ignition switch is turned to the start position, check for battery voltage to the starter solenoid. This will determine if the solenoid is receiving the correct voltage from the ignition switch. Connect a 12-volt test light or a voltmeter to the starter solenoid positive terminal. While an assistant turns the ignition switch to the start position, observe the test light or voltmeter. The test light should shine brightly or battery voltage should be indicated on the voltmeter.