Jeep RL801852AB Starter Motor

To prepare for removing the starter, follow these initial steps, disconnect the cable from the negative terminal of the battery. Raise the vehicle and ensure it is securely supported on jack stands. Remove the middle engine splash shield. Secure the steering wheel to prevent it from rotating freely.

Remove the two support bracket bolts at the transmission, then pry the support bracket aside enough to gain access to the lower starter mounting bolt. Additionally, on some 4WD models the driveshaft will have to be detached from the front differential companion flange for access to the starter mounting bolts.

If the starter does not activate when the ignition switch is turned to the start position, check for battery voltage to the starter solenoid. This will determine if the solenoid is receiving the correct voltage from the ignition switch. Connect a 12-volt test light or a voltmeter to the starter solenoid positive terminal. While an assistant turns the ignition switch to the start position, observe the test light or voltmeter. The test light should shine brightly or battery voltage should be indicated on the voltmeter.

Installation is the reverse of removal for all engine types.