Make sure this part fits your vehicle

Mopar 5272486AB Front Steering Knuckle

2005-2010 Mopar 5272486AB

Mopar 5272486AB Front Steering Knuckle
  • Part Description
  • Position
  • Replaced By
  • Manufacturer
Customer Questions & Answers
$164.12 MSRP: $299.00
You Save: $134.88 (46%)
  • Product Specifications

    BrandGenuine Mopar
    Manufacturer Part Number5272486AB
    Part DescriptionKnuckle-Front
    Item Dimensions11.6 x 11.4 x 6.3 inches
    Item Weight11.80 Pounds
    Fitment TypeDirect Replacement
    Shipping & ReturnShipping Policy Return Policy
    Warning: California’s Proposition 65
  • Vehicle Fitment

    Year Make Model Engine Important vehicle option details
    2005-2010 Chrysler PT Cruiser4 Cyl 2.4LBase, Base Convertible, Classic, GT, GT Convertible, Limited, Touring, Touring Convertible
    2005 Dodge Neon4 Cyl 2.0L, 4 Cyl 2.4LSE, SRT-4, SXT

Customer Questions & Answers

Will this fit my truck? Posted by MoparPartsGiant Specialist
You can Select Your Vehicle to check if 5272486AB fits your vehicle.
Posted by MoparPartsGiant Specialist
How Do You Remove and Install a Front Hub and Steering Knuckle Assembly? Posted by Customer
To remove the front hub and steering knuckle assembly, start by removing the hub cap, cotter pin, nut lock, and spring washer with the vehicle weight resting on the front suspension. Loosen the drive axle/hub nut and wheel lug nuts without completely removing them. Then, raise the front of the vehicle, secure it on jackstands, and remove the wheel. Proceed to remove the brake caliper, pads, and caliper mounting bracket from the steering knuckle, and hang the caliper out of the way. Disconnect the tie-rod end from the steering knuckle and loosen the strut-to-steering knuckle bolts. Detach the ground strap bracket and ABS sensor harness bracket from the strut if equipped. Also, detach the control arm ball joint from the steering knuckle. With the knuckle and hub assembly in the straight-ahead position, pull it directly out and off the drive axle splines, being careful not to pull the drive axle out. You may need to tap on the axle end with a soft-face hammer to dislodge it from the hub. Secure the end of the drive axle with wire to prevent damage. To install the new hub and steering knuckle assembly, clean the CV joint boot and hub grease seal with solvent, then lubricate the CV joint wear sleeve and seal contact surface, as well as the splines at the end of the drive axle with multi-purpose grease. Carefully place the knuckle and hub assembly in position, align the splines of the axle and hub, and slide the hub into place. Install the strut-to-knuckle bolts and nuts, followed by the ball joint pinch bolt and nut. Reattach the tie-rod end to the steering knuckle, then install the brake disc, caliper mounting bracket, pads, and caliper. Reattach the ground strap and ABS sensor harness bracket(s) to the strut. Install the washer and drive axle/hub nut, tightening it securely. Install the wheels and lug nuts, lower the vehicle, and tighten the lug nuts. Finally, tighten the drive axle/hub nut, install the spring washer, nut lock, and a new cotter pin, and if applicable, have the front end alignment checked and adjusted if special camber adjusting bolts have been installed.
Posted by MoparPartsGiant Specialist
If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Genuine Mopar Part 5272486AB, the Right Choice

Your vehicle deserves only genuine OEM Mopar parts and accessories. To ensure reliability, purchase Mopar part # 5272486AB Front Steering Knuckle. It is sometimes referred to as Mopar Steering Knuckle. Our Mopar parts and accessories are expedited directly from authorized Mopar dealers strategically located all across the U.S. and are backed by the manufacturer's 12 month, 12,000 mile warranty. OEM Mopar parts are the best for restoring your vehicle to factory condition performance. This part fits specific Chrysler PT Cruiser models. It fits Dodge Neon.

Affordable, reliable and built to last, Mopar part # 5272486AB Front Steering Knuckle stands out as the smart option. is your prime online source with the biggest and best selection of genuine Mopar parts and accessories at giant discounted prices. We have the OEM Mopar parts and accessories you need at the wholesale prices. has you covered no matter what type of Mopar vehicle you drive. For detailed Dodge parts information, click here.

Why choose Mopar Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly