Mopar 5018697AA Fuel Pump/Level Module Kit

You can Select Your Vehicle to check if 5018697AA fits your vehicle.

Separate the two components.

Depress the connector retaining tab and remove the fuel pump/fuel level sending unit electrical connector from the underside of the fuel pump module electrical connector. Remove the wedge lock from the electrical connector and use a special terminal remover tool or a suitable similar tool to remove the terminals from the fuel level sending unit connector. Depress the tab and slide the fuel level sending unit toward the bottom of the fuel pump module, then slide it out of the channel in the fuel pump module.

If you suspect insufficient fuel delivery, there are several checks you can perform. First, check the battery to ensure it is fully charged. Next, inspect the fuel filter for any obstructions. Additionally, examine the fuel line, hoses, and quick-connect fittings for any issues. To verify if the fuel pump is running, have an assistant turn the ignition switch to ON while you listen for the sound of the fuel pump operating. If the fuel pump does not make any noise, check the fuel pump electrical circuit. If the fuel pump runs but the problem persists, proceed to the fuel pump pressure check. To perform this check, relieve the fuel system pressure and connect a fuel pressure gauge to the test port on the fuel rail. Start the engine and let it idle, ensuring the fuel pressure falls within the specified range. If the pressure is too high, replace the fuel pressure regulator. If the pressure is too low, check for leaks in the fuel line, hoses, connectors, and fuel injectors. Inspect the fuel strainer for any restrictions and consider replacing the fuel pump module if necessary. Finally, if the fuel pump does not turn on, check the fuel pump fuse and relay. If these components are functioning properly and the fuel pump still does not operate, have the circuit checked by a professional.

Depress the connector retaining tab and remove the fuel pump/fuel level sending unit electrical connector from the underside of the fuel pump module electrical connector. Remove the wedge lock from the electrical connector and use a special terminal remover tool or a suitable similar tool to remove the terminals from the fuel level sending unit connector. Depress the tab and slide the fuel level sending unit toward the bottom of the fuel pump module, then slide it out of the channel in the fuel pump module.