My Garage
My Account
Cart
Genuine Dodge Magnum Exhaust Manifold
Engine Exhaust Manifold- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
12 Exhaust Manifolds found
Dodge Magnum Exhaust Manifold
The Exhaust Manifold in Dodge Magnum vehicles contributes greatly as it helps in channeling hot exhausts from the engine to the exhaust system thus enhancing efficient working of the vehicle and minimizing emissions. Located at various places on the engine block, the manifold works as an obstacle against intake reversion that if takes place detracts air flow and thus the efficiency of the engine. Dodge Magnum exhaust manifolds are normally made from cast iron or stainless steel while headers, which are considered as parts, are said to improve performance through improving exhaust flow. These headers enhance velocity of the exhaust gas, and thus the output of the engine is enhanced. The design of the exhaust manifold is also different and the number of pipes depend on the number of the cylinders of the engine and for instance there are Magnum cars that have V6 engine.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Magnum Exhaust Manifold at great affordable prices. Moreover, all genuine Dodge Magnum Exhaust Manifold come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Dodge Magnum Exhaust Manifold Parts Questions & Experts Answers
- Q: How to remove and install an exhaust manifold in 3.5L V6 engine on Dodge Magnum?A:Disconnect the cable from the negative terminal of the battery. Raise the front of the vehicle and support it securely on jackstands. Remove the engine splash shield. Disconnect the oxygen sensors' electrical connectors and remove the sensors. Detach the exhaust pipes from the exhaust manifolds. Lower the vehicle. Remove the exhaust manifold heat shield mounting bolts/nuts and remove the heat shields. Remove the mounting bolts and detach the manifold from the cylinder head. Be sure to spray penetrating oil on the bolts before attempting to remove them. Clean the mating surfaces to remove all traces of old gasket material, then inspect the manifold for distortion and cracks. Warpage can be checked with a precision straightedge held against the mating flange. If a feeler gauge thicker than 0.030-inch can be inserted between the straightedge and flange surface, take the manifold to an automotive machine shop for resurfacing. Place the exhaust manifold in position with a new gasket and install the mounting bolts finger tight. Be sure to identify the exhaust manifold gaskets by the correct cylinder designation and the position of the exhaust ports on the gasket. Starting in the middle and working out toward the ends, tighten the mounting bolts in several increments, to the torque. Install the remaining components in the reverse order of removal. Start the engine and check for exhaust leaks between the manifold and cylinder head and between the manifold and exhaust pipe.
