My Garage
My Account
Cart
Genuine Jeep Patriot Ignition Switch
Starter Ignition Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Ignition Switches found
Jeep Patriot Ignition Switch
Jeep Patriot Ignition Switch plays the major part in starting and charging functions of automotive where it is used for starting the engine and powering other electrical equipment like radio and power window. The Ignition Switch by a key, button or a remote means sends a signal to the vehicle's computer to start the starter motor and other parts of the ignition system. It has been noted that in the various Jeep Patriot models that have ever been produced in the market, both the mechanical keys as well as the keyless start technology have been used. The latter uses a push button for its activation with the need of a transponder signal. The sophistication of the systems has grown from mechanical keys to keyless systems and this change is due to innovation in vehicle engineering. In any case the Ignition Switch in Jeep Patriot cars is intended to remove and substitute and bypasses the line is a plug-and-play system considering the individual car.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Patriot Ignition Switch at great affordable prices. Moreover, all genuine Jeep Patriot Ignition Switch come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Patriot Ignition Switch Parts Questions & Experts Answers
- Q: How to replace the ignition lock cylinder and ignition switch on the Jeep Patriot?A:To replace the ignition switch one has to remove upper and lower steering column covers, lock the steering column in the 'full-down' position, insert the key into the Legendary Lock and position it in the Run position. Pull back the small safety tab on the ignition switch and release the connectors, disconnect the larger connector by unscrewing the bolt that holds the switch in place and pulling the switch out of the steering column. For the lock cylinder, same as with the ignition, the upper and lower steering column covers have to be removed, the steering column has to be locked and key has to inserted in the Run position. If required, there will be a fastener to the skreem/wcm where the tabs can be removed and the skreem/wcm slid backwards slightly to reveal the lock cylinder release tab. With a small flat head screwdriver pull the lock cylinder release tab up and remove the key and the lock cylinder as a single unit. For installation, the key should be inserted into the lock and rotated backwards to the run position, it is also important to line up of the slots of the lock cylinder to the housing before it is inserted and clips into place. Switch off the key and try to rotate it and ensure that the key and the cylinder work correctly. The SKREEM/WCM which translates to Sentry Key Remote Entry Module or Wireless Control Module is very essential in the alarm system it has receivers for entry without use of keys and for tire pressure. It has a circular Antenna through which it establishes contact with a microprocessor chip in the factory programmed key used in the ignition of the vehicle. The new SKREEM/WCM module shall be programmed by using a diagnostic scan tool before driving the vehicle and it is recommended that two keys at least should be programmed. To remove the SKREEM/WCM: Disconnect and set aside the Wiper Switch, unscrew the lock cylinder housing, pry the retaining arms of it back and slide the SKREEM/WCM module off. Installation instructions are the opposite of removal ones.
