Jeep 5184293AC Damper Crankshaft

Disconnect the negative battery cable from the remote ground terminal. Loosen the lug nuts on the right front wheel, raise the front of the vehicle, and support it securely on jackstands. Remove the right front wheel and inner fender liner. Remove the right engine mount. Remove the accessory drive belts. Connect an engine hoist to the engine and support it. Remove the lower crossmember. Lower the engine enough to position a large screwdriver through the crankshaft pulley to keep the crankshaft from turning, and remove the pulley-to-crankshaft bolt. Pull the crankshaft pulley off the crankshaft with a puller, ensuring the jaws of the puller only contact the hub of the pulley and not the outer ring. A spacer or long Allen-head bolt must be inserted into the crankshaft nose for the puller's tapered tip to push against, avoiding contact with the crankshaft itself. To install the crankshaft pulley, slide it onto the crankshaft as far as it will go, then use a vibration damper installation tool to press it onto the crankshaft. Install the crankshaft pulley retaining bolt and tighten it to the specified torque. The remainder of installation follows the reverse order of removal.