Remove the rocker arms and pushrods. Remove the intake and exhaust manifolds.Remove the drivebelt(s). Unbolt the power steering pump (if equipped) and set it aside without disconnecting the hoses.On air conditioned models, remove the bolt that secures the air conditioning compressor/alternator bracket to the cylinder head, then unbolt the compressor/alternator bracket from the engine. Set the compressor aside without disconnecting the hoses.Label, then disconnect the wire from the coolant temperature sending unit on the cylinder head. Label the spark plug wires and remove the spark plugs.Remove the ten bolts that secure the cylinder head and lift it off the engine. If the head is stuck to the engine block, it may be necessary to tap it with a soft-face hammer or a block of wood and a hammer to break the seal. Stuff clean shop towels into the cylinders. Thoroughly clean the gasket surfaces removing all traces of gasket material. Run an appropriate sized tap into the bolt holes in the cylinder head and run a die over the bolt threads. Ensure all bolt holes are clean and dry.Inspect the cylinder head for cracks and check it for warpage. 1984 through 1987 four-cylinder engines use different head gaskets than 1988 and later models. The two types of gaskets are NOT interchangeable and require different tightening torques.These engines use stamped steel gaskets. Apply an even coat of a copper coat type gasket sealant to both sides of the new gasket.These engines use a composition gasket. Install it dry (without any sealing compound).Install the new gasket with the word Top on the cylinder head side. Place the cylinder head on the engine.Coat the threads of the stud bolt (no. 8 in the tightening sequence) with Teflon pipe sealant. Install the bolts and tighten them. Tighten them. Install the remaining components in the reverse order of removal.Change the oil and filter.Refill the cooling system and run the engine, checking for leaks and proper operation.