Mopar 68233466AC Instrument Panel Cluster

The instrument panel removal and installation procedure can be very difficult and is not recommended for novice mechanics; ensure comfort with mechanical abilities before starting. Begin by disconnecting the cable from the negative battery terminal. Next, remove the driver's side and passenger's side instrument panel end caps, followed by the center console and floor shifter housing. Proceed to remove the transmission shifter assembly, door sill panels, kick panels, knee bolster, HVAC control assembly, radio, defroster trim panel, and under-glove box closeout panel. Disconnect the blower motor and resistor electrical connectors, then remove the A-pillar trim panels and the steering column. Disconnect the electrical connectors from the A-pillars and the radio antenna connector from the passenger's side kick panel area. Detach the center wiring harness from the retaining clips, and in the driver's side kick panel area, disconnect the main wiring harness connectors and release the on-board diagnostic connector port from the bracket below. Remove the instrument panel center mounting bolts from the radio opening, followed by the side mounting bolts from both sides of the vehicle, and the lower-center support bolts. Finally, remove the upper bolts and, with assistance, carefully guide the instrument panel out of the vehicle, ensuring all electrical connections are disconnected and wiring harness clips are detached. Installation is the reverse of removal.

Disconnect the cable from the negative battery terminal. Remove the instrument panel upper trim cover. Remove the instrument cluster mounting fasteners. Disconnect the electrical connectors and remove the cluster. Installation is the reverse of removal.