Mopar 5303746AF Passenger Side Headlight Assembly

The vertical headlight adjustment screw, located on the inside corner of the housing, controls up-and-down movement. The adjustment screw on the outside corner controls the left-and-right movement. There are several methods of adjusting the headlights. The simplest method requires a blank wall 25 feet in front of the vehicle and a level floor. Position masking tape on the wall in reference to the vehicle center line and the center lines of both headlights. Measure the height of the headlight reference marks (in the centers of the headlight lenses) from the ground. Position a horizontal tape line on the wall at the same height as the headlight reference marks. It may be easier to position the tape on the wall with the vehicle parked only a few inches away. Adjustment should be made with the vehicle sitting level, the gas tank half-full and no unusually heavy load in the vehicle. Turn on the low beams. Turn the adjusting screw to position the high intensity zone so it is two inches below the horizontal line. Have the headlights adjusted by a dealer service department at the earliest opportunity.