Mopar 5096150AA Fuel Tank Sending Unit

You can Select Your Vehicle to check if 5096150AA fits your vehicle.

Inspect the inlet strainer and clean or replace if necessary.

Remove the fuel pump/fuel pressure regulator/Fuel Level Sensor assembly. Depress the release tab and disconnect the electrical connector from the underside of the fuel pump/fuel pressure regulator/Fuel Level Sensor assembly. Remove the wedge lock from the electrical connector. Using a special terminal removal tool or a suitable substitute, disengage each terminal from the electrical connector and pull out the wire and terminal from the backside of the connector. Note the positions of the wires; they must be returned to their original locations. The Fuel Level Sensor is secured to the fuel pump housing by a pair of mounting rails on the side of the housing. To remove the sensor from these two rails you must disengage a pair of locking lugs, located on the underside of the sensor, that can only be disengaged from the mounting rails by aligning them with the cutouts in the rails. Using an awl or a small screwdriver, carefully lever the lug on the Fuel Level Sensor toward the area between the two mounting rails until it disengages from the locking lug on the upper rail. Then slide the sensor to the left until the lugs on the underside of the sensor are aligned with the cutouts in the mounting rails and lift off the sensor. Installation is the reverse of removal.