How to Replace a Water Pump on a Dodge Magnum?

Disconnect the cable from the negative battery terminal. Drain the cooling system and save the coolant if it is in good condition. Remove the engine cooling fan assembly. Remove the drivebelt. For 2.7L V6 engines, remove the timing chain and guides. For 3.5L V6 engines, remove the timing belt. For 5.7L VS engines, remove the thermostat. Detach the radiator hose from the water pump and remove the idler pulley for the drivebelt. Remove the water pump from the engine, noting the locations of the bolts. Clean the bolt threads and threaded holes. Compare the new pump to the old one and check the impeller blades for corrosion. Remove old gasket material or O-ring seal. Clean the mating surfaces with lacquer thinner or acetone. Apply RTV sealant to the new water pump O-ring or gasket. Attach the pump to the engine and tighten the bolts in a criss-cross pattern. Connect the hoses and reinstall all removed parts. Refill the cooling system, run the engine, and check for leaks.

Genuine Dodge Magnum Water Pump

H2O Pump

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Water Pumps found

View related parts
Dodge Magnum Water Pump
Part Number: 4792838AB
$192.30 MSRP: $284.00
You Save: $91.70 (33%)
ADD TO CART
Product Specifications
- Other Name: Pump-Water; Water Pump Assembly
- Replaced by: 68670653AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2006 Dodge Magnum | R/T AWD, R/T RWD, SE RWD | 8 Cyl 5.7L
View related parts
Dodge Magnum Water Pump
Part Number: 4892225AA
$145.62 MSRP: $217.00
You Save: $71.38 (33%)
ADD TO CART
Product Specifications
- Other Name: Pump-Water
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007 Dodge Magnum | SE RWD | 6 Cyl 2.7L
View related parts
Dodge Magnum Water Pump
Part Number: 4892425AA
$145.13 MSRP: $215.00
You Save: $69.87 (33%)
ADD TO CART
Product Specifications
- Other Name: Pump-Water
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2008 Dodge Magnum | SE RWD | 6 Cyl 2.7L
View related parts
Dodge Magnum Engine Cooling Water Pump
Part Number: 4792838AA
$192.30 MSRP: $284.00
You Save: $91.70 (33%)
ADD TO CART
Product Specifications
- Other Name: Pump-Water
- Replaced by: 68670653AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005-2007 Dodge Magnum | R/T AWD, R/T RWD, SE RWD, SRT8 RWD | 8 Cyl 5.7L, 8 Cyl 6.1L
View related parts
Dodge Magnum Water Pump
Part Number: 4792968AD
$159.75 MSRP: $242.00
You Save: $82.25 (34%)
ADD TO CART
Product Specifications
- Other Name: Pump-Water
- Replaced by: 4792968AF
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005-2008 Dodge Magnum | SE RWD, SXT AWD, SXT RWD | 6 Cyl 3.5L
View related parts
Dodge Magnum Engine Cooling Water Pump
Part Number: 4663732AC
$81.10 MSRP: $120.00
You Save: $38.90 (33%)
ADD TO CART
Product Specifications
- Other Name: Pump-Water
- Replaced by: 4663732AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005-2006 Dodge Magnum | SE RWD | 6 Cyl 2.7L

Dodge Magnum Water Pump

The water pump in Dodge Magnum is a very important component that is used to circulate coolants within the engines water jacket. This process enables the coolant to collect heat produced during the combustion process then let it out in the radiator. Typically, Dodge Magnum Water Pumps employed belts but there have been improvements with the water pumps that are electric, they have advantages that include less parasitic loss, additionally, provide better control of the flow of the coolant depending on what the engine temperature is. Over the years, there has been a shift of Dodge Magnum Water Pumps from the cast iron type to lightweight aluminum casting type. Performance options are offered to allow for larger impellers and passages in order to move more coolant, for street and strip use. These performance water pumps do more than increase the rate of cooling, they also decrease the amount of power needed to run it thus freeing more horse power to the wheels.

Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Dodge Magnum Water Pump at great affordable prices. Moreover, all genuine Dodge Magnum Water Pump come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.

Dodge Magnum Water Pump Parts Questions & Experts Answers

Water Pump
4892425AA
Q: How to Replace a Water Pump on a Dodge Magnum?
A:
Disconnect the cable from the negative battery terminal. Drain the cooling system and save the coolant if it is in good condition. Remove the Engine Cooling Fan assembly. Remove the drivebelt. For 2.7L V6 engines, remove the timing chain and guides. For 3.5L V6 engines, remove the timing belt. For 5.7L VS engines, remove the Thermostat. Detach the radiator hose from the water pump and remove the idler pulley for the drivebelt. Remove the water pump from the engine, noting the locations of the bolts. Clean the bolt threads and threaded holes. Compare the new pump to the old one and check the impeller blades for corrosion. Remove old gasket material or O-ring seal. Clean the mating surfaces with lacquer thinner or acetone. Apply RTV sealant to the new water pump O-ring or gasket. Attach the pump to the engine and tighten the bolts in a criss-cross pattern. Connect the hoses and reinstall all removed parts. Refill the cooling system, run the engine, and check for leaks.