Mopar BD034700AA Storage

The battery is located in the engine compartment, and the battery cables are accessible after opening the hood.

Corrosion can be removed with a baking soda solution. After removing the corrosion, rinse the area and cover damaged metal parts with zinc-based primer and paint.

Loosen the left-front wheel lug nuts, then raise the front of the vehicle and support it on jackstands. Remove the left-front wheel and inner fender splash shield. Also remove the engine under cover. Remove the fuse box assembly mounting bolts and position it to the side. Remove the Powertrain Control Module (PCM) mounting bolts, then position it to the side. If necessary, also remove the PCM mount for better access. Detach any wiring harness clips from the battery tray, then remove the battery tray mounting bolts - accessed by working from the engine compartment, fenderwell, and from below the vehicle. Remove the battery tray, rotating it as necessary. Installation is the reverse of removal.

Trickle chargers typically take 12 to 16 hours to charge a battery fully. The exact charging time may vary depending on the charger and the state of charge of the battery.

A routine preventive maintenance program for the battery in your vehicle is essential to ensure quick and reliable starts. Proper battery maintenance helps prolong the battery's life and ensures that it functions as intended.

Remove the battery, followed by the tray liner if one exists. Finally, remove the battery tray fasteners and lift the tray out.

To disconnect the battery for service procedures requiring power to be cut from the vehicle, simply loosen the cable clamp nut and disconnect the cable from the negative battery terminal. It is important to isolate the cable end to prevent accidental contact with the battery terminal.