Genuine 1992 Dodge Colt Distributor

1992 Dodge Colt Distributor Parts Questions & Experts Answers

• Q: What should be done if a distributor becomes excessively worn and how should it be replaced on 1992 Dodge Colt?

  A: If the distributor becomes worn to such an extent that there is side movement of the shaft within the body of the distributor, it is advisable to get a new distributor of the same serial number so as to ensure close ignition advance curves and engine performance are attained. All other major components are considered replaceable, and disassembly starts with the distributor out of the engine, which indicates the places of the two governor springs and distinguishes them. The IC igniter and pick up coil need to be removed once the two securing screws are unscrewed: it is important not to clean the silicone grease on the back of the IC igniter. The vacuum control unit is then removed from the distributor housing, this is amended by the withdrawal of the breaker arm assembly which must be protected from scrap iron or dust. Before withdrawing the locking pin, it is necessary to indicate the position of the driven gear to the distributor shaft; the bearing securing plate is then removed to facilitate lifting of the shaft out of the housing. Reassembly is done in reverse to the disassembly, also to ensure that if the gear was changed, the location of the rotor is at the number 1 cylinder firing position. The gear is placed on the shaft by sliding it to fit the other end of the shaft; when the corresponding marks reach each other a new locking pin is inserted. Based on the design and construction, grease is deposited to all dynamic parts mainly the parts with sliding parts, and the breaker assembly is cleaned of iron dust and once in place, it ensures that the signal rotor does not come into contact with the breaker assembly stator when in rotation.