My Garage
My Account
Cart
Genuine Jeep Patriot Ignition Lock Cylinder
Ignition Key Lock Cylinder- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Ignition Lock Cylinder found
Jeep Patriot Cylinder-Ignition Lock
Part Number: 5179511AA$56.89 MSRP: $119.00You Save: $62.11 (53%)
Jeep Patriot Ignition Lock Cylinder
Assuming the function of the Ignition Lock Cylinder in Jeep Patriot, every driver knows that it is an element designed for placing and rotating the key in order to activate the engine. This component is located in the switch of ignition, it simply uses the correct key to direct from the battery the required circuits. The Ignition Lock Cylinder for the Jeep Patriot has been changed over time with earlier models having normal single keys to start the car while the later models may contain smart keys that have to signify with the computer of the Jeep Patriot to start the car. However, it is important to note that even with the said development, the Ignition Lock Cylinder may wear out hence causing a challenge when twisting the key or inserting it into the ignition to switch on the engine. Problems might be resulting from old keys or tumbler or even mechanical problems with the Ignition switch. The Jeep Patriot design focuses on the car's protection and durability and the Ignition Lock Cylinder as a mechanical unit of the car may undergo wear and tear and therefore need to be replaced or repaired.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Jeep Patriot Ignition Lock Cylinder at great affordable prices. Moreover, all genuine Jeep Patriot Ignition Lock Cylinder come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Jeep Patriot Ignition Lock Cylinder Parts Questions & Experts Answers
- Q: How to replace the ignition lock cylinder and ignition switch on the Jeep Patriot?A:To replace the ignition switch one has to remove upper and lower steering column covers, lock the steering column in the 'full-down' position, insert the key into the Legendary Lock and position it in the Run position. Pull back the small safety tab on the ignition switch and release the connectors, disconnect the larger connector by unscrewing the bolt that holds the switch in place and pulling the switch out of the steering column. For the lock cylinder, same as with the ignition, the upper and lower steering column covers have to be removed, the steering column has to be locked and key has to inserted in the Run position. If required, there will be a fastener to the skreem/wcm where the tabs can be removed and the skreem/wcm slid backwards slightly to reveal the lock cylinder release tab. With a small flat head screwdriver pull the lock cylinder release tab up and remove the key and the lock cylinder as a single unit. For installation, the key should be inserted into the lock and rotated backwards to the run position, it is also important to line up of the slots of the lock cylinder to the housing before it is inserted and clips into place. Switch off the key and try to rotate it and ensure that the key and the cylinder work correctly. The SKREEM/WCM which translates to Sentry Key Remote Entry Module or Wireless Control Module is very essential in the alarm system it has receivers for entry without use of keys and for tire pressure. It has a circular Antenna through which it establishes contact with a microprocessor chip in the factory programmed key used in the ignition of the vehicle. The new SKREEM/WCM module shall be programmed by using a diagnostic scan tool before driving the vehicle and it is recommended that two keys at least should be programmed. To remove the SKREEM/WCM: Disconnect and set aside the Wiper Switch, unscrew the lock cylinder housing, pry the retaining arms of it back and slide the SKREEM/WCM module off. Installation instructions are the opposite of removal ones.
